Working principle: Cold state non cutting plastic processing; The high-pressure hydraulic drive causes the mold to close, allowing the aluminum sleeve to flow fully in the mold cavity and tightly wrap around the steel wire rope strands. By relying on the friction between the steel wires and the shaping and locking of the sleeve body, a high-strength joint is formed without damaging the original wire strength of the steel wire rope;
Standard requirement: The breaking force after crimping is usually not less than 90% of the nominal breaking force of the steel wire rope (industry/national standard regulations), and the pressure and mold must be matched according to the specifications;
Process: Rope cutting→ Wearing a suit→ Positioning→ Apply pressure (single/multiple)→ Demoulding→ Tensile testing.